Mobile Phone

 Click Cancel to close the Extract dialog box.

2. You are going to use these extracted elements to create the wireframe geometry:

 Click on the Parallel Curve icon  .

 Select the shortest pink extracted curve as element to offset, and the yellow face as support:

 Click OK to confirm.

 Click on the point creation icon  .

 Select the “on curve” type and the previous parallel curve as support. Create this point:

 Click on the Parallel Curve icon  .

 Select the second pink extracted curve as element to offset, and the yellow face as support:

 Click on the Parallel Curve icon  .

 Select the first pink extracted curve as element to offset and the yellow face as support:

 Click on the Connect Curve icon .

 Create this connect curve:

 Click on the project icon   and project the previous connect curve to the yellow extracted face: 

Click on the point icon and create a point on the YZ plane using these parameters: 

 Click on the circle icon   and create a circle using the previous point as center, YZ plane as support and the following parameters:

Step 2: Creating the Surfaces

Load the part called CATGSD_F_Phone_Step2_start.CATPart from the ''Companion'' and save the part in the Students directory.

Insert a new open body:

Rename it “Surfaces”:

- Click with the third mouse button on the new created open body and select “Properties”:

1. You are going to create the two points that will be used to create the sweep sections:

 Double-click on the Point icon  .

 Select the point type “on curve” and create these two points on the corner curve:

 Click Cancel to close the Point dialog box.

2. You are going to create the adaptative sweep using the corner curve, these two points and the extracted face:

 Click on the Adaptative sweep icon  .

 Select the corner curve as guiding curve:

 Now you are going to create the section:

- Right click in the sketch field and select “Create sketch”:

- This dialog box appears:

- Select this point:

 Click OK to confirm the adaptative sweep creation:

1. You are going to create a linear sweep using the circle as guiding curve:

 Click on the sweep icon  .

 Choose the linear sweep type and the sub-type “with reference surface”  

 Choose the circle as guide curve and the YZ plane as reference surface: